Polycom G7500 Reference Manual page 101

Auto - System tries to automatically find an available gatekeeper.
Specify - Calls use the specified gatekeeper. Set this value if if you want to use
voIpProt.H323.gk.auth.enable.
voIpProt.H323.name
How gatekeepers and gateways identify your system. You can make point-to-point calls using H.
323 names if both systems are registered to a gatekeeper.
The value here is the same set for device.local.deviceName unless you change it. (Your
organization's dial plan might define the name you can use.)
String (0-36)
${h323_ID} - RealPresence Resource Manager accepts this value to automatically configure the
parameter.
voIpProt.SIP.auth.useLoginCredentials
Specifies if you want to register with a SIP service using the same credentials you used for
registering with a provisioning service.
With this parameter, provisioning separate username, password, and domain parameters for the
SIP service isn't necessary.
0 (default)
1
voIpProt.SIP.auth.password
The password associated with the username for authenticating your system with a SIP registrar
server.
String
voIpProt.SIP.bfcpTransportPreference
Controls content sharing negotiation behavior. Using the Binary Floor Control Protocol (BFCP),
a relationship is established between the floor control server and its clients. What you set here
determines how network traffic flows between the server and clients.
Prefer_UDP (default) - Starts resource sharing using UDP but falls back to TCP if needed.
Prefer_TCP - Starts resource sharing using TCP but falls back to UDP if needed.
UDP_ONLY - Shares resources only using UDP. If UDP is unavailable, content sharing in a
separate video stream isn't available.
TCP_ONLY - Shares resources only through TCP. If TCP is unavailable, content sharing in a
separate video stream isn't available.
Note: TCP is typically known as slightly slower but more reliable than UDP. It is not
supported under some circumstances, such as with session border controllers
(SBCs).
voIpProt.SIP.enable
Enables or disables the ability for your system to use the SIP protocol.
You must set to "1" to use other voIpProt.SIP.* parameters.
If set to "0", you can't also set voIpProt.H323.enable="0".
0 (default)
1
Polycom, Inc.
VoIP Parameters
99