Polycom G7500 Reference Manual page 47

device.net.secondaryNetwork.subnetMask
Specifies the subnet mask address for the Wi-Fi network.
String
255.255.255.0
device.net.subnetMask
Specifies the subnet mask address for the wired LAN.
You don't need to set this if device.net.mode="Automatically".
String
255.255.255.0
device.net.domain
Identifies the domain your system belongs to.
Set this if the system does not automatically obtain a domain name.
String
device.net.dot1x.enable
Specifies whether EAP/802.1X network access is enabled. The following authentication
protocols are supported:
EAP-MD5
EAP-PEAPv0 (MSCHAPv2)
EAP-TTLS
EAP-TLS
0 (default)
1
device.net.dot1x.identity
Specifies the system's identity used for 802.1X authentication.
String (0-64)
device.net.dot1x.password
Specifies the system's password used for 802.1X authentication. This setting is required when
EAP-MD5, EAP-PEAPv0, or EAP-TTLS is used.
String
device.net.echo.enable
When enabled, your system sends an ICMP Echo Reply message in response to a broadcast or
multicast Echo Request that isn't specifically addressed to the system.
0 (default)
1
device.net.ethernet.autoNegotiation
Specifies whether the system should automatically negotiate the LAN speed and duplex mode
per IEEE 802.3 autonegotiation procedures.
Polycom recommends that you use autonegotiation to avoid network issues.
Polycom, Inc.
Network Parameters
45