Table of Contents
Advertisement
2.8 Terminal configuration.
Once the EFTPOS 1i terminal is connected, the Merchant ID and Terminal ID will need
to be entered into the PC-EFTPOS EFT Client. This is done via the Control Panel –
your POS Vendor or PC-EFTPOS Help Desk may be able to assist you if required.
You can use the function on the keypad from the terminal idle screen to configure the
primary communications method. To do this, press the # key at the idle screen and
enter 998 to proceed to communications selection.
The following configuration options will be displayed:
1. Bluetooth Base: View the details of the connected Bluetooth base hardware,
and press "1" to unpair from the base so that your terminal can be paired with
another base.
2. Bluetooth Base Version: View the firmware version of the connected Bluetooth
base, and press "2" to update the base firmware if required.
3. POS Details: View details on the POS interface methodology (such as RS232).
4. SIM: Press "4" to verify the SIM details (if installed).
5. PSTN Details: Press "5" to verify the PSTN phone number (if in use).
6. Power off timer: Press "6" to configure the power-off timer duration.
7. (not in use).
8. Internal Modem: Press "8" to configure which communications method should be
used to communicate with the bank in the event that POS Communications are
down. The available options are GPRS, PSTN, and None.
Note that these communications method configurations are for the handset
communicating directly with the host (via GPRS or PSTN) in the event that the POS-to-
Bank link is down.
The host communications (GPRS or PSTN) will only be used in the event that the POS
communications to the bank are down (and/or the terminal is in standalone lite mode),
and this process should be seamless during a transaction.
6
WESTPAC EFTPOS 1i TERMINAL USER GUIDE
Advertisement
Table of Contents
