Connecting Power - Christie CP2308-C Installation And Setup Manual

b) Insert your right index and middle finger through the back of the reflector and guide the
lamp onto the cathode clamp.
Be careful not to hit the lamp against the reflector.
c) Thread on and hand-tighten the cathode nut. Ensure the smooth portion of the nut is
against the cathode clamp.
d) Tighten the cathode screw (D) with a hex key.
13. Align the ring terminal on the anode wire with the mounting position ensuring the crimped side
of the wire is facing out.
14. Tighten the anode screw.
15. Route anode lead away from nearby metal surfaces.
16. Close the lamp access door and tighten the two thumbscrews.
17. Close the fire wall door and tighten the two thumbscrews.
18. Close and lock the rear access door. Ensure the hex key is placed back into its holder before
closing the rear access door.

Connecting power

Connect the projector to the power source.
Warning! Failure to comply with the following could result in death or serious injury.
• SHOCK HAZARD! A dedicated, protected ground or earth wire must be installed on the product
by Christie qualified technicians or electricians before it can be connected to power.
• SHOCK HAZARD! Only use the AC power cord provided with the product or recommended by
Christie.
• FIRE AND SHOCK HAZARD! Do not attempt operation unless the power cord, power socket, and
power plug meet the appropriate local rating standards.
• SHOCK HAZARD! The AC power cord must be inserted into an outlet with grounding.
• SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and power range, as specified on the license label.
• SHOCK HAZARD! Disconnect the product from AC before moving, servicing, cleaning, removing
components, or opening any enclosure.
• The appliance coupler and main power supply plug must be easily accessible for disconnecting
the product from the power source.
Caution! Failure to comply with the following could result in minor or moderate injury.
• Only Christie qualified technicians are permitted to open product enclosures.
• Install the product near an easily accessible AC receptacle.
• For products containing surge suppressors, you must adhere to the installation and power
requirements.
Installation and Power Requirements
The protected earth wire must be green/yellow 12 AWG minimum.
You must use a 20A branch circuit breaker for Input A.
CP2308-C Installation and Setup Manual
020-102492-01 Rev. 1 (01-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Installation and setup
19