Installation and setup
Learn how to install, connect, and optimize the projector.
This section provides detailed information on projector setup.
Lifting and positioning the projector
Safely lift and position the projector in the location where it will be used.
Warning! Failure to comply with the following could result in death or serious injury.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
1. Position each person at the corners of the projector.
2. Place both hands under the corner, grasping the baseplate.
Do not lift the projector by inserting your fingers into the spaces in the skin and pulling on the
skin louvers.
3. Lift up the projector and move it to the location where it will be used.
4. Position the projector so it is centered and parallel with the theater screen. If space is limited,
aim the projector slightly off-center and use lens offset to center the image on the screen.
Light intensity hazard distance
This projector has been classified as Risk Group 3 as per the IEC62471 standard due to possible
hazardous optical and thermal radiation being emitted.
Warning! Failure to comply with the following could result in serious injury.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam must be
permitted.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! Operators must control access to the beam
within the hazard distance or install the product at the height (greater than or equal to 2.0 m
from the floor to the beam) that prevents exposure of spectators' eyes within the hazard
distance.
•
EXTREME BRIGHTNESS! Do not place reflective objects in the product light path.
The following diagram shows the zones for optical and thermal radiation hazard distances:
CP2308-C Installation and Setup Manual
020-102492-01 Rev. 1 (01-2017)
Copyright
2017 Christie Digital Systems USA Inc. All rights reserved.
©
9