Christie CP2308-C Installation And Setup Manual page 13

5. Repeat steps 3 to 5 to install the three remaining stacking cups.
6. With the assistance of another person, lift the second projector and position it on top of the
bottom projector so each of its feet fit into a stacking cup. The lenses of both projectors must
face the same direction and the optical axis of both projector lenses must be parallel (A) and
align vertically (B).
7. Install both projectors.
a) Install the touch panel (on page 14).
b) Install the lens (on page 15).
c) Install the lamp (on page 17).
d) Connect devices to the projector (on page 22).
e) Connect power (on page 19).
f) Adjust the bottom projector image to fit the screen. For more information, see the
CP2308-C User Manual.
g) Align the top projector image to the bottom projector image. For more information, see
the CP2308-C User Manual.
8. When both projectors are installed and aligned correctly, install the locking brackets on the
feet of the top projector.
a) Slide the locking bracket (011-104470-XX) over the flat sides of the stacking cup, so the
notch in the locking bracket fits around the projector leg and above projector foot nut.
b) Turn the locking bracket so the flanges of the locking bracket fit tightly below the stacking
cup tabs.
c) Repeat steps a and b to install the three remaining locking brackets
CP2308-C Installation and Setup Manual
020-102492-01 Rev. 1 (01-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Installation and setup
13