Installing The Lens - Christie CP2308-C Installation And Setup Manual

A Mounting arm
B Ball joint
4. Tighten the mounting arm until if fits tightly on the ball joint.
5. Connect the touch panel harness to the touch panel:
a) Connect one end of the USB cable to the USB port on the rear of the touch panel.
b) Connect one end of the touch panel power cable to the DC IN 12V port on the rear of the
touch panel.
c) Connect one end of the VGA connector to the VGA port on the rear of the touch panel.
6. Connect the touch panel harness to the projector:
a) Connect the other end of the USB cable to a USB port on the projector input panel.
b) Connect the other end of the touch panel power cable to the Screen Power port on the
projector input panel.
c) Connect the other end of the VGA connector to the VGA Out port on the projector input
panel.
7. Press the power button on the top of the touch panel to turn it on.
If the projector is not connected to AC power, you cannot turn the touch panel on.

Installing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Before installing the lens, ensure that you turn off and unplug the projector.
Do not operate the projector without a lens installed. Install a lens plug when you install or transport
the projector.
CP2308-C Installation and Setup Manual
020-102492-01 Rev. 1 (01-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Installation and setup
15