7) Close the enclosure door and secure the handle with the two security screws.
Note: Ensure that the battery On/Off switch is in the On position before closing the access door or the backup
battery will not work when it is most required.
8.11 Return to Factory Setting
Note: Admin level access is required
User can reset all TPPLW user configuration setting to factory setting
1) Log in as Admin
2) Select Maintenance > Service Mode > Reset to Default
All I/O modules must be added in HW Module Control Panel menu again. Refer to the Ch.8.4 How to add a new
Figure 37. Battery On/Off Switch and Battery Connector
All mA input channel gas calibrations, Relay output setting will be initialized.
Passwords are not changed by Reset to Default.
Touchpoint Plus Wireless