MAN0984_Iss 2_09/19
3020M5001_2
Chapter 6 – Touchpoint Plus Wireless Operating Instructions
6.1 User Interface General
The User Interface panel (shown above) has:
•
A colour touchscreen for normal system operation, maintenance and configuration
•
Power, Alarm / Fault and Inhibit state LEDs
•
Active Channel (01 to 08) status indicators (Ch. 07 is NOT commissioned in this example)
•
R1 to R8 indicate active RAEPoint in the system
•
Accept (Silence) and Reset membrane button (Right side)
•
Integral Alarm Buzzer (Left side)
Further System Interfaces consist of:
•
Remote inhibit and remote reset terminals on the Main module
•
One fixed relay and two configurable relays on Main Module for system Failure, Alarm and inhibit
•
Three dedicated alarm outputs for visual and audio alarms on Main module
•
An optional SD card
The interface firmware has two distinct modes of operation – Configuration Mode and Visualisation Mode, and
access to certain functions is restricted by the use of password protected access levels. There are four
hierarchical access levels: View mode is available to all users while Operator, Service and Administrator
modes are password protected. Password holders can be assigned one access level only.
Direct sunlight, solvents, abrasives and sharp edged or metal tools may cause irreparable damage
Operating Instructions
Figure 35. Touchpoint Plus Wireless Controller User Interface
to the LCD panel and membrane.
Use only damp cloths or computer screen wipes to clean it.
41
CAUTION
Touchpoint Plus Wireless
Technical Handbook