Configuring Relay Output Channels - Honeywell Touchpoint Plus Wireless Technical Handbook

MAN0984_Iss 2_09/19
3020M5001_2

7.6.6 Configuring Relay Output Channels

Note: You need to complete Configuring analog input and wireless channels
Note: You need to complete Network setting for wireless nodes
To configure an individual channel:
1) Login as Service or higher level
2) Select Menu > Configuration > Channel settings
3) Select the required Relay Output Module
4) Select the required channel and confirm by touching 'Select'
5) Set Enable a channel
6) Select 'Assign type' to select among 'Sensor', 'Monitor' or 'Wind sensor', 'Digital In' or 'MANDOWN'.
7) Set others and touch 'Finish'
8) Check if all settings are correct and select 'Apply'
9) Check if all settings are correct and select 'Update'
10) Repeat steps 5 to 9 for all Relay channels
Commissioning
65
Touchpoint Plus Wireless
Technical Handbook