Input 1 or 2 Set Up Wiring
Thermocouple Inputs using a Millivolt Source
Refer to Figure "Wiring Connections for Thermocouple Inputs using a
Millivolt Source" and wire the controller according to the procedure
given in Table "Set Up Wiring Procedure for Thermocouple Inputs
using a Millivolt Source".
Table 6-3: Set Up Wiring Procedure for Thermocouple Inputs using a Millivolt Source
Step
Action
1
Connect the copper leads to the terminals for Input #1 as shown in the
following figure "Wiring Connections for Thermocouple Inputs using a Millivolt
Source".
Figure 6-2: Wiring Connections for Thermocouple Inputs using a
Millivolt Source
RTD Inputs
Refer to Figure "Wiring Connections for RTD (Resistance
Thermometer Device)" and wire the controller according to the
procedure given in Table "Set Up Wiring Procedure for RTD Inputs".
Table 6-4: Set Up Wiring Procedure for RTD Inputs
Step
Action
1
Connect the copper leads from the calibrator to the Input #1 terminals as
shown in Figure "Wiring Connections for RTD (Resistance Thermometer
Device)".
Chapter 6 - Input Calibration
232