How To Change The Sd Card; Figure 36. Sd Card Location - Honeywell Touchpoint Plus Wireless Technical Handbook

MAN0984_Iss 2_09/19
3020M5001_2
5) Insert the SD card containing the update file into the UI module.
6) Login as an administrator.
7) Select the Menu > Maintenance > Update system > Software.
8) Select a Module browse the appropriate firmware file in the SD card. Check the listed current and update
versions. And touch 'Update' to continue
9) When the updates are completed, the system requires power reset.
10) Remove the SD card and refit the event logging SD card.
11) Close the door and secure the access handle.
12) Check that the system status is OK and no faults, inhibits or errors are shown.

8.9 How to Change the SD Card

Note: The system can accept standard SD cards from 2 to 32 GB (FAT32), and will provide a notification
when the card is less than 50Mbyte free space.
To change the SD Card:
1) Ensure that it is safe to open the enclosure. Unscrew the two handle security screws and then pull the
handle to open the enclosure door.
2) Select then Menu > Maintenance > SD Card > Eject.
3) When prompted, remove the SD Card and insert a replacement 2 to 32 GB (FAT32) card. Note the correct
orientation in the picture below.
4) Confirm that the screen shows the SD Card as being correctly inserted and its usage is free space is
sufficient
5) Close the access door and secure the locking handle.
Switch off and isolate power before inserting or removing SD card if used in a hazardous location, e.g. Class 1
Maintenance

Figure 36. SD Card Location

DANGER
Division 2
84
Touchpoint Plus Wireless
Technical Handbook