Network Switching Mode - Honeywell CIPer 50 User Manual

CIPer MODEL 50 CONTROLLER – USER GUIDE
TM

Network switching mode

Optionally, the Dual Ethernet can be operated in network switching mode.
If this mode is desired, disable one of the Ethernet ports in WEBs N4 – see screenshot below.
Typical application scenarios are a closed BMS networks, like for daisy-chaining plant controllers or daisy-chaining
room controllers on Ethernet.
NOTE
The switching functionality will not work during the power-fail of the CIPer Model 50 controller.
IMPORTANT
Set a gateway address
For the Ethernet switching functionality to work, it is mandatory to enter a Gateway address. If there is
no gateway in the subnet, then use a gateway address that relates to the IP address of the Ethernet
adapter that is enabled.
In the screenshot below, the gateway address is 192.168.1.1, hence the IP address of Ethernet adapter 1 must be
in the range of 192.168.1.2 to 192.168.1.255.
31-00198-03 18