Sl Command; Dh Command; Dl Command; Ci (Cluster Id) - Digi DigiMesh XBee S2C User Manual

AT commands

SL command

Displays the lower 32 bits of the unique IEEE 64-bit RF extended address assigned to the product
family in the factory.
The 64-bit source address is always enabled. This value is read-only and it never changes.
Parameter range
0 - 0xFFFFFFFF [read-only]
Default
Set in the factory

DH command

Set or read the upper 32 bits of the 64-bit destination address. When you combine DH with DL, it
defines the destination address that the device uses for transmissions in Transparent mode.
The destination address is also used for I/O sampling in both Transparent and API modes.
0x000000000000FFFF is the broadcast address. It is also used as the polling address when the device
functions as end device.
Parameter range
0 - 0xFFFFFFFF
Default
0

DL command

Set or display the lower 32 bits of the 64-bit destination address. When you combine DH with DL, it
defines the destination address that the device uses for transmissions in Transparent mode.
The destination address is also used for I/O sampling in both Transparent and API modes.
0x000000000000FFFF is the broadcast address. It is also used as the polling address when the device
functions as end device.
Parameter range
0 - 0xFFFFFFFF
Default
0xFFFF

CI (Cluster ID)

The application layer cluster ID value. The device uses this value as the cluster ID for all data
transmissions in Transparent mode and for all transmissions performed with the
frame - 0x10 in API mode. In API mode, transmissions performed with the
Command frame - 0x11
If you set this value to 0x12 (loopback Cluster ID), the destination node echoes any transmitted
packet back to the source device.
XBee S2C DigiMesh 2.4 User Guide
ignore this parameter.
Addressing commands
Transmit Request
Explicit Addressing
83