Pd (Pull Up/Down Direction) - Digi DigiMesh XBee S2C User Manual

AT commands
Parameter
0
1
Default
1
P8 (SPI_SCLK )P8 (SPI_SCLK )
Sets or displays the SPI_SCLK configuration (TH pin 18/SMT pin 14).
This only applies to surface-mount devices.
Parameter range
1, 2
Parameter
0
1
Default
1
P9 (SPI_ATTN)
Sets or displays the SPI_ATTN configuration (pin 12).
This only applies to surface-mount devices.
Parameter range
1, 2
Parameter
0
1
Default
1

PD (Pull Up/Down Direction)

The resistor pull direction bit field (1 = pull-up, 0 = pull-down) for corresponding I/O lines that are set
by the PR command.
See PR (Pull-up/Down Resistor Enable)
XBee S2C DigiMesh 2.4 User Guide
Description
Disabled
SPI_SSEL
Description
Disabled
SPI_SCLK
Description
Disabled
SPI_ATTN
for the bit mappings.
I/O settings commands
99