Pr (Pull-Up/Down Resistor Enable); M0 (Pwm0 Duty Cycle) - Digi DigiMesh XBee S2C User Manual

AT commands
Parameter range
0x0 - 0x7FFF
Default
0x1FFF

PR (Pull-up/Down Resistor Enable)

PR and PD only affect lines that are configured as digital inputs or disabled.
The following table defines the bit-field map for PR and PD commands.
The bit field that configures the internal pull-up/down resistor status for the I/O lines. If you set a PR
bit to 1, it enables the pull-up/down resistor; 0 specifies no internal pull-up/down. The following table
defines the bit-field map for both the PR and PD commands. The pull resistor direction is controlled by
the PD command.
Bit I/O line
0 DIO4 (pin 11 for through-hole, pin 24 for surface-mount)
1 DIO3/AD3 (pin 17 for through-hole, pin 30 for surface-mount)
2 DIO2/AD2 (pin 18 for through-hole, pin 31 for surface-mount)
3 DIO1/AD1 (pin 19 for through-hole, pin 32 for surface-mount)
4 DIO0/AD0 (pin 20 for through-hole, pin 33 for surface-mount)
DIO6/RTS (pin 16 for through-hole, pin 29 for surface-mount)
5
6 DIO8/SLEEP_REQUEST (pin 9 for through-hole, pin 10 for surface-mount)
DIO14/DIN/CONFIG (pin 3 for through-hole, pin 4 for surface-mount)
7
8 DIO5/ASSOCIATE (pin 15 for through-hole, pin 28 for surface-mount)
DIO9/ON_SLEEP(pin 13 for through-hole, pin 26 for surface-mount)
9
10 DIO12/SPI_MISO (pin 4 for through-hole), DIO12 (pin 5 for surface-mount)
11 DIO10/RSSI/PWM0 (pin 6 for through-hole, pin 7 for surface-mount)
12 DIO11/PWM1 (pin 7 for through-hole, pin 8 for surface-mount)
DIO7/CTS (pin 12 for through-hole, pin 25 for surface-mount)
13
14 DOUT (pin 2)
Parameter range
0 - 0x7FFF (bit field)
Default
0x1FFF

M0 (PWM0 Duty Cycle)

The duty cycle of the PWM0 line (TH pin 6/SMT pin 7).
XBee S2C DigiMesh 2.4 User Guide
I/O settings commands
100