Technical Specifications; Performance Specifications; Power Requirements - Digi DigiMesh XBee S2C User Manual

Technical specifications

Performance specifications

The following table describes the performance specifications for the devices.
Specification
Indoor / urban range
Outdoor RF line-of-sight range
Transmit power output (software
selectable)
RF data rate
Maximum data throughput
UART interface data rate
SPI data rate
Receiver sensitivity

Power requirements

The following table describes the power requirements for the XBee/XBee-PRO S2C DigiMesh 2.4 RF
Module.
Specification
Supply voltage
Transmit current (typical, VCC = 3.3 V)
Idle / receive current (typical, VCC = 3.3 V)
Power-down current
1 Boost mode enabled by default; see
2 See Regulatory information
XBee S2C DigiMesh 2.4 User Guide
XBee value
Up to 200 ft (60 m)
Up to 4000 ft (1200 m)
6.3 mW (8 dBm), Boost mode
3.1 mW (5 dBm), Normal mode
Channel 26 max power is 0.3 mW (-5
dBm)
250,000 b/s
TBD
1200 b/s to 250,000 b/s
Up to 5 Mb/s (burst)
-102 dBm, Boost mode
-100 dBm, Normal mode
XBee
2.1 - 3.6 V
45 mA (8 dBm, Boost mode)
33 mA (5 dBm, Normal mode)
31 mA (Boost mode)
28 mA (Normal mode)
<1 uA @ 25C
PM (Power Mode).
for region-specific certification requirements.
Performance specifications
XBee-PRO value
Up to 300 ft. (90 m)
Up to 2 miles (3200
m)
1
63 mW (18 dBm)
250,000 b/s
TBD
1200 b/s to 250,000
b/s
Up to 5 Mb/s (burst)
-101 dBm
XBee-PRO
2.7 - 3.6 V
120 mA (18 dBm)
31 mA
<1 uA @ 25C
2
13