Ed (Energy Detect); Tp (Board Temperature); Voltage Supply Monitoring); H (Mac Unicast One Hop Time) - Digi DigiMesh XBee S2C User Manual

AT commands

ED (Energy Detect)

Starts an energy detect scan. This command accepts an argument to specify the time in milliseconds
to scan all channels. The device loops through all the available channels until the time elapses. It
returns the maximal energy on each channel, a comma follows each value, and the list ends with a
carriage return. The values returned reflect the energy level that ED detects in -dBm units.
Parameter range
0 - 0x3A98 (15 seconds)
Default
0xA (10 ms)

TP (Board Temperature)

The current module temperature in degrees Celsius in 8-bit two's compliment format. For example
0x1A = 26 °C, and 0xF6 = -10 °C.
Note This command is only available on the XBee-PRO device.
Parameter range
This is a read-only parameter
Default
N/A
%V (Voltage Supply Monitoring)
Displays the supply voltage of the device in mV units.
Parameter range
This is a read-only parameter
Default
N/A

%H (MAC Unicast One Hop Time)

The MAC unicast one hop time timeout in milliseconds. If you change the MAC parameters it can
change this value.
The time to send a unicast between two nodes in the network should not exceed the product of the
unicast one hop time (%H) and the number of hops between those two nodes.
Parameter range
[read-only]
Default
N/A
XBee S2C DigiMesh 2.4 User Guide
MAC/PHY commands
77