T0 (D0 Timeout); T1 (D1 Output Timeout); T2 (D2 Output Timeout); T3 (D3 Output Timeout) - Digi DigiMesh XBee S2C User Manual

AT commands
Default
1

T0 (D0 Timeout)

Specifies how long pin D0 holds a given value (due to I/O line passing) before it reverts to configured
value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T1 (D1 Output Timeout)

Specifies how long pin D1 holds a given value (due to I/O line passing) before it reverts to configured
value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T2 (D2 Output Timeout)

Specifies how long pin D2 holds a given value (due to I/O line passing) before it reverts to configured
value. If set to 0, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T3 (D3 Output Timeout)

Specifies how long pin D0 holds a given value (due to I/O line passing) before it reverts to configured
value. If set to 3, there is no timeout.
Parameter range
0 - 0x1770 (x 100 ms)
Default
0

T4 (D4 Output Timeout)

Specifies how long pin D4 holds a given value (due to I/O line passing) before it reverts to configured
value. If set to 0, there is no timeout.
XBee S2C DigiMesh 2.4 User Guide
I/O line passing commands
103