If (Sleep Sample Rate); Ir (Sample Rate); Is Command; Sleep Commands - Digi DigiMesh XBee S2C User Manual

AT commands

IF (Sleep Sample Rate)

Set or read the number of sleep cycles that must elapse between periodic I/O samples. This allows
the firmware to take I/O samples only during some wake cycles. During those cycles, the firmware
takes I/O samples at the rate specified by IR.
Parameter range
1 - 0xFF
Default
1
t b

IR (Sample Rate)

Set or read the I/O sample rate to enable periodic sampling. When set, this parameter causes the
device to sample all enabled DIO and ADC at a specified interval.
To enable periodic sampling, set IR to a non-zero value, and enable the analog or digital I/O
functionality of at least one device pin (see
Configuration)- P2 (DIO12/SPI_MISO
WARNING! If you set IR to 1 or 2, the device will not keep up and many samples will be
lost.
Parameter range
0 - 0xFFFF (x 1 ms)
Default
0

IS command

Forces a read of all enabled digital and analog input lines. The data is returned through the UART or
SPI.
See Monitor I/O lines.
Parameter range
N/A
Default
N/A

Sleep commands

The following AT commands are sleep commands.
XBee S2C DigiMesh 2.4 User Guide
D0 (DIO0/AD0) -D9 (ON_SLEEP),
Configuration).
Sleep commands
P0 (DIO10/RSSI/PWM0
107