Installation Guide Linear Motors
5.1.2 Mounting
Page 18 / 32
1. Dismounting front bearing set
2. Mounting front bearing set
3. Dismounting rear bearing set
4. Mounting rear bearing set
P10-54 / P10-54-D24/25/25S
Remove the end piece and the bearing
bushing at the front end of the stator.
Note! With the stator P10-54x120 there is
only 1 bearing bushing for the whole length.
The bearing bushing is pushed in as far as
it will go. Then screw the end piece
together with the 2 pan-head screws.
Tightening torque:
The pan-head screws are already coated
with Tuflok.
Remove the end piece and the bearing
bushing at the front end of the stator.
Note! With the stator P10-54x120 there is
only 1 bearing bushing for the whole length.
The bearing bushing is pushed in as far as
it will go. Then screw the end piece
together with the 2 pan-head screws.
Tightening torque:
The pan-head screws are already coated
with Tuflok.
NTI AG / LinMot
ENG
1.2 Nm
1.2 Nm