Table of Contents
Advertisement
Installation Guide Linear Motors
After the installation of the slider a safety label must be placed close to the slider.
Page 12 / 32
4. Installing the slider using the fixed
5. Mount floating bearing
6. Move stator (back end) to the fixed end
7. Move stator (front side) to the floating
P10-54 / P10-54-D24/25/25S
bearing
The fixed bearing is screwed to the front
end of the slider.
Important! Do not tighten the screw yet!
Imortant!
Do not tighten the screw!
The slider is allowed to extend into the
floating bearing no more than 15 mm!
of slider, center slider in stator and
tighten the screw.
bearing and tighten screws.
NTI AG / LinMot
ENG
Advertisement
Table of Contents
