Installation Guide Linear Motors
3.6.1 Assembling instruction
Please attend to the safety instructions in chapter 2 during the assembling!
If moving stator application is used, the minimum bending radius of the motor cable should
be adhered to. See chapter Cable, section Technical Data.
NTI AG / LinMot
1. Mount stator to its support bearing.
2. Placing a spacer
3. Insert slider into stator.
P10-54 / P10-54-D24/25/25S
Put a spacer (wood, plasic, aluminium with
thickness 15 mm) between slider and linear
guide. The spacer prevents injuries to the
hands and damage to the slider surface!
ENG
Page 11 / 32