Modbus To Modbus Configuration Page - Comtrol DeviceMaster EtherNet/IP-Modbus EIP-MOD User Manual

Modbus to Modbus Configuration Page

7.3. Modbus to Modbus Configuration Page

Need supporting information.
1. Click Data Mapping | Modbus to Modbus to open the Modbus to Modbus Configuration page.
2. Click the Add Default Configuration button.
The following table provides information about the options on this page.
Line
Active
DeviceMaster EIP-MOD User Guide: 2000664 Rev. A
Modbus to Modbus Configuration Page
This is the configuration line number.
• If the configuration entry has been saved, the line number is not directly
modifiable.
• If the configuration entry is in the process of being added and has not been
saved, then the line number can be set to anywhere in the configuration
list.
- The placement of the entry in the saved list is in relation to the current
list of saved entries. For example, if you wish to place an entry before
the current 4th entry, then enter 4 for the line number.
- If more than one entry is added at one time, the order is preserved but
final line numbers may or may not be the same as the selected
numbers.
If selected, the configuration becomes active when the Save button is clicked.
The Data Mapping process immediately begins to perform the configured
operations.
If not selected, the configuration becomes inactive when the Save button is
clicked. The Data Mapping process then ignores the configured operations.
Chapter 7. Data Mapping Menus - 75