Comtrol DeviceMaster EtherNet/IP-Modbus EIP-MOD User Manual page 117

Modbus to Modbus Diagnostics Page
Function code
Address (base 1)
Tx Messages
Rx Messages
No Path
Error Responses
Invalid Responses
Reset Statistics
DeviceMaster EIP-MOD User Guide: 2000664 Rev. A
Modbus to Tag/File Diagnostics Page
Displays the function being used to perform the write operation.
Displays the Modbus address in Base 1 format.
Displays the number of write messages transmitted to the Shared Memory or
Modbus device.
Displays the number of valid write responses received from the Shared Memory
or Modbus device.
Displays the number of no path conditions. No path conditions occur when any
of the following occur:
• There is no valid destination to send the Modbus message.
- There are no serial ports configured as slave ports.
- There is no remote Modbus configuration for the device ID.
• If there is a remote Modbus configuration, the gateway is unable to connect
to the Modbus/TCP IP address.
Displays the number of write response errors received from the Shared Memory
or Modbus device.
Displays the number of invalid write responses received from the Shared
Memory or Modbus device. These occur when an incorrect function code is
received in the response, or a response message is received when it is not
expected.
Resets the statistics to all zeros.
Chapter 8. Diagnostic Menus - 117