Technical Data - ersa i-CON 1V Operating Instructions Manual

Technical data

2. Technical data
Soldering station
Designation
Dimensions, mm
Weight, kg
Mains voltage, VAC
Mains frequency
Fuse (slow blowing), A
Operating voltage, VAC
Mains frequency, Hz
Fuse (slow blowing), A
Secondary voltage, VAC
Maximum short-term heating output, W
Mean heating output
Class of protection
Permissible ambient temperature, °C
Temperature range (stepless), °C, °F
Control oscillations in idle state, °C
Ohmic resistance between soldering tip and ground, Ohm
Soldering tip to ground rebound voltage, mV eff
Equipotential bonding socket, mm
Rear side interface
Two tools operable at the same time
Miscellaneous
Control technology
Function display
Conformity
Supply cable 2 m, PVC, with appliance socket
Single-button operation via incremental encoder (i-OP)
Anti-static surface, especially suitable for use in ESD areas.
Acc. to MIL-SPEC/ESA-standard
VDE, EMC-tested
Connectable soldering and desoldering devices (depending on model): i-TOOL, CHIP TOOL, CHIP TOOL VARIO,
X-TOOL, X-TOOL VARIO, TECH TOOL, MICRO TOOL, POWER TOOL, i-SET TOOL
Optionally available: Serial interface for actuating the Easy Arm 1 and Easy Arm 2 soldering fume extraction
systems or the 0IRHP100A heating plate
64 3BA00231 · 2019-03-12 · Rev. 4
i-CON 1V
Value
150 x 175 x 105
3.0
220-240
50-60
0.8
110-120
50-60
1,6
24
150
80
I
0-40
50-450, 122-842
< ± 2
< 2
< 2
4
Ersa soldering fume extraction system,
IRHP 100 pre-heating plate, ready signal,
standby signal
-
SENSOTRONIC (PID-characteristic), RESIS-
TRONIC
LC-Display, blue
Ersa i-CON 1V & i-CON 2V
i-CON 2V
Value
3.7
120
Yes