Heating Plate; Connecting Heating Plate To Soldering Station; Activating The Heating Plate - ersa i-CON 1V Operating Instructions Manual

Functional description
6.3.17

Heating plate

This function is only guaranteed if the soldering station is provided with a PC serial
interface (optional). With the soldering station you can control the 0IRHP100A infrared
heating plate.
The following accessories are needed:
• Control cable from the soldering station to the 0IRHP100A
• Y control cable if the soldering fume extraction system and the 0IRHP100A infrared
heating plate are to be controlled together.
6.3.17.1

Connecting heating plate to soldering station

■
Connect the control cable of the 0IRHP100A heating plate with the control cable of
the soldering station.
■
Switch on the heating plate.
6.3.17.2

Activating the heating plate

92
■
Press i-OP to activate the cursor, pressing i-OP again
deactivates the cursor.
■
Enter the desired time from [010] to [240] minutes by
turning i-OP accordingly. By entering [000] the [idle
state] function is disabled.
With the cursor activated, the parameter value can be changed accord-
ingly by turning the i-OP. The set time starts to run only after the tool is
in [Standby]. If the tool is not used during this time, idle state is activated
after this time has lapsed.
Idle state is automatically exited as soon as the soldering tool is removed
from the workstand or i-OP.
A controlled heating plate is not automatically activated! With regard to
this, please read section 6.2 [The working mode].
■
In configuration mode select the [Heating plate] menu
by turning i-OP.
■
Activate the cursor by pressing i-OP.
3BA00231 · 2019-03-12 · Rev. 4 Ersa i-CON 1V & i-CON 2V