Safety Instructions - ersa i-CON 1V Operating Instructions Manual

Concerning your safety
3.2

Safety instructions

68
WARNING! Malfunctions of the device possible!
Check all components before each use. Have damaged parts only
repaired by a specialist or the manufacturer. If repairs are carried out
inappropriately, the operator may become victim of accidents. Always
use original Ersa spare parts for possible repairs.
ATTENTION Risk of burning!
Thermal tools get very hot. Before heating up the device check wheth-
er the tool insert (e.g. soldering tip, modeling insert, etc.) is correctly
connected with the thermal tool. The hot tool insert should never come
in contact with skin, hair or any heat-sensitive and combustible materials.
Make sure you use a sufficiently heat proof work base.
ATTENTION Risk of injury!
Keep unauthorized persons at a safe distance. Make sure that unautho-
rized persons, especially children, have no access to the thermal tools.
ATTENTION! Fire hazard!
Before heating up the thermal tool remove any combustible objects, flu-
ids and gases from the working range of the thermal tool. If work is inter-
rupted, always store the thermal tool in the workstand provided for this
purpose. Disconnect the thermal tool from the mains supply after use.
ATTENTION! Fire hazard!
Do not leave your hot thermal tool unattended. Remember that it will
take quite some time for the tool insert to cool down to a harmless tem-
perature, after the device has been switched off.
ATTENTION Risk of injury!
Keep your working area clean and tidy. A messy working area increases
the risk of accidents.
3BA00231 · 2019-03-12 · Rev. 4 Ersa i-CON 1V & i-CON 2V