Changing The Password; Input Without Disabling The Password - ersa i-CON 1V Operating Instructions Manual

Functional description
The [Configuration] display will appear with the message [PASSWORD PROTECTION:
ACTIVE]. The station is now protected.
6.3.13.2

Changing the password

The password is set in configuration mode. If a password has already been set, the code
will appear "hidden".
If the user would like to change a password, the active password protection must first be
revoked by entering the current password.
After a correct input, the new password can be set. If the numerical input is completed
via the PUSH function, a note will appear to inform you that password protection has
been activated. This note should once again inform the operator about the severity of
this function. If the function is interrupted, the previous status will be maintained.
If the operator continues the dialog [>>>], the password needs to be repeated for activa-
tion.
6.3.13.3

Input without disabling the password

If entries are made during this period of time, the length of time is extended by another
30 s so that further entries can be made. If no other entries are made during a 30 s time
span, password protection is activated again.
90
The second display [Password activation] appears:
■
Enter the password once again and press i-OP to con-
firm your entry.
If the password is repeated correctly, the station will be
protected by the code. If the code is entered incorrectly,
you will receive a message stating that the previous condi-
tion will be maintained.
The a key symbol signals that the station is protected.
If values are to be changed, e.g. a target value, without
disabling your password, you will be required to enter
your password before making any change. If the correct
password is entered, the user has approx. 30 s time to
make its changes.
3BA00231 · 2019-03-12 · Rev. 4 Ersa i-CON 1V & i-CON 2V