1MAC108982-MB E
5.1.5
5.1.6
615 series ANSI
Engineering Manual
Configuration parameters
Configuration parameters can be viewed and set with the Parameter Setting tool.
Connections and variables
A connection is the link or "wire" between function block outputs and inputs.
There are rules and methods for making connections.
•
Drag a line between two signals
•
Link two signals by using variables
It is possible to search and replace variable names in Application
Configuration tool.
Connect the variables to a destination, for example to a function block or
a hardware output channel. The connectivity package automatically
removes the orphan variables which are not connected to any destination.
Connection validation
A connection is only useful or even possible between two signals of the same base
attribute type.
GUID-720C9C93-AB56-4AEB-AF72-7E136E62A87F-ANSI V1 EN
Figure 52:
Application Configuration tool: an error message of a signal mismatch for
a connection
Protection and control engineering
Section 5
83