Functions, Codes And Symbols - ABB RELION 615 Series Engineering Manual

Section 1
Introduction
1.4.3
Table 1: Functions included in the relays
Function IEC 61850
Protection
Three-phase non- PHLPTOC1
directional overcurrent
PHLPTOC2
protection, low stage
Three-phase non- PHHPTOC1
directional overcurrent
PHHPTOC2
protection, high stage
Three-phase non- PHIPTOC1
directional overcurrent
PHIPTOC2
protection, instantaneous
stage
Three-phase directional DPHLPDOC1
overcurrent protection, low
DPHLPDOC2
stage
Three-phase directional DPHHPDOC1
overcurrent protection,
DPHHPDOC2
high stage
Three-phase voltage- PHPVOC1
dependent overcurrent
protection
Non-directional ground- EFLPTOC1
fault protection, low stage
EFLPTOC2
Non-directional ground- EFHPTOC1
fault protection, high stage
EFHPTOC2
EFHPTOC3
EFHPTOC4
Table continues on next page
8
To navigate between the options, use
• Menu paths are presented in bold.
Select Main menu/Settings.
• LHMI messages are shown in Courier font.
To save the changes in nonvolatile memory, select Yes and press
• Parameter names are shown in italics.
The function can be enabled and disabled with the Operation setting.
• Parameter values are indicated with quotation marks.
The corresponding parameter values are "Enabled" and "Disabled".
• Input/output messages and monitored data names are shown in Courier font.
When the function picks up, the PICKUP output is set to TRUE.
• Dimensions are provided both in inches and mm. If it is not specifically mentioned,
the dimension is in mm.
• This document assumes that the parameter setting visibility is "Advanced".

Functions, codes and symbols

All available functions are listed in the table. All of them may not be applicable to all
products.
IEC 60617
RED615
3I> (1)
3I> (2)
3I>> (1)
3I>> (2)
3I>>> (1) 50P-3
3I>>> (2)
3I> -> (1) 67/51P-1
3I> -> (2) 67/51P-2
3I>> -> (1) 67/50P-1
3I>> -> (2)
3I(U)> (1)
Io> (1)
Io> (2)
Io>> (1) 50G-1
Io>> (2)
Io>> (3)
Io>> (4)
and .
ANSI/C37.2-2008
REF615 REG615
51P-1 51P-1
51P-2
50P-1 50P-1
50P-2
50P-3 50P-3
67/51P-1 67/51P-1
67/51P-2
67/50P-1 67/50P-1
67/50P-2
51V
51G
51N-1
50G-1 50G-1
50G-2
50N-1
50N-2
1MAC108982-MB E
.
REM615 RET615
51P 51P (1)
51P (2)
50P-1 50P-1 (1)
50P-2 50P-1 (2)
50P-3 50P-3 (1)
50P-3 (2)
67/51P-1(2)
67/51P-2(2)
51G
51N (2)
50G-1
50G-2 50G-2 (2)
615 series ANSI
Engineering Manual