Com600S Project; Selecting Communication Port For Configuration - ABB RELION 615 Series Engineering Manual

1MAC108982-MB E
4.5
4.5.1
615 series ANSI
Engineering Manual
GUID-B4B71E12-25CB-4B8B-8F9A-90131BD68E4D V3 EN
Figure 37: Alternative 2: Setting the IP address in IED's Object Properties dialog box
Choosing between the two ways depends on when the IP address is set. Typing the IP
address via the IED's Object Properties dialog box is possible at any time while entering
it via the configuration wizard can only be done when adding the IED object.
1. In the Plant Structure view, select the IED to which the IP address is to be entered.
2. On the View menu, select Object Properties.
Object Properties dialog box is opened.
3. Type in the IP address to the IP Address row.

COM600S project

The 615 series connectivity package supports SAB600. A 615 series protection relay is
imported as a 615 series device. It is also possible to import a full PCM600 project
including several 615 series devices to SAB600. In this case, PCM600 project information
is imported to SAB600 using a SCD file.
The 615 series device supports several functions in COM600S.
• Controlling the switchgear
• Monitoring the measured values
• Reading digital fault recordings
• Setting parameters

Selecting communication port for configuration

When a relay is configured to a PCM600 project, the connection between the relay and the
tool can be established using a point-to-point link between the relay front port and the
computer or by connecting the computer to the relay rear port over an Ethernet station bus.
Section 4
Setting up a project
65