Validation; Validation When Creating An Application Configuration; Validation On Demand - ABB RELION 615 Series Engineering Manual

1MAC108982-MB E
5.1.9
5.1.9.1
5.1.9.2
615 series ANSI
Engineering Manual
Online monitoring can be started by clicking the Work online button in the toolbar. If the
application configurations in the IED and PCM600 are the same, the online monitoring
starts. The online monitoring ends and the tool returns to the configuration mode if the
Work Offline button is clicked.
Online monitoring cannot be started if the application configuration in
IED and PCM600 are different.
In some cases when the function block input is directly mapped to the
function block output, the input is internally forced to the correct value
depending of the function block's settings. This kind of function block
design is present in control blocks, setting group handling and tap
changer.

Validation

Validation checks the application configuration for errors based on the rules that govern
the creation of the application at three different times.
• During the logic creation, while making a connection or placing a function block
• On demand by starting the validation
• When writing the application configuration to the protection relay

Validation when creating an application configuration

Validation is made when creating the application configuration.
• A connection between two input or two output signals is not possible
• A connection between two different data types is not possible: for example, from a
binary output to an analog input

Validation on demand

The validity of an application configuration can be checked by clicking Validate
Configuration in the toolbar. The Application Configuration tool checks the application
configuration for formal correctness. The found problems are divided into warnings and
errors.
• Warnings, marked with a yellow warning icon
Protection and control engineering
Section 5
85