Table of Contents
Advertisement
B A l l E RY
( not
i n c I
u
d e d
)
Minimum requirements:
12V
-
110 Ah marine cranking battery
If boat is equipped with dual outboard motors, two
batteries must be installed, one for each motor.
In the event that a battery failure makes it necessary to
temporarily use one battery for two motors, disconnect
the engine ground wire from between the two switch
panel.
(+)
TERMINAL
(red)
1
w l
BAlTERY 12V 1lOAh
(commercially available)
Install the battery in the correct size corrosion-resistant
battery box, in a dry, well-ventilated location protected
from water and direct sunlight.
Connect the positive
(+)
battery cable first, then connect
the negative
(4
battery cable. Tighten cable nuts securely.
Coat the battery terminal ends with the non-conductive
grease. Cover the battery positive
(+)
terminal.
Secure the corrosion-resistant battery box properly to
the boat. To keep potential sparks away from the fuel
tank, do not secure or place battery near the fuel tank.
Wire Connection
Route and connect the wire harness properly, as shown in
the wiring diagram.
Use switch panel wire harness and indicator panel wire
harness.
Connect the connectors securely. If a terminal is oxidized
or corroded, remove the oxidation or corrosion with a
nonconductive plastic scrub pad or contact cleaner before
reconnecting
it.
The switch panel wire harness is 5 m (16.4 ft) in length.
If this is too short to route, we recommended that you use
the extension harness (2 m/6.6
f t
in length). Note that the
extension harnesses can be used up two harnesses with
the total length 9 m (29.7
ft)
or below.
If the indicator panel wire harness is too short to route,
use the extension harness (5 d 1 6 . 4 f t in length) for
indicator panel wire harness.
Make sure insulators surround their connectors completely
and that the ends are not folded up.
Do not break the wire harness coverings. If the covering of
a wire is broken, either repair
it
with electrician's tape, or
replace it.
Attach unused terminals to the adjacent main harness
with a piece of vinyl tape so that the terminals don't interfere
with the surrounding parts.
Connect each wire properly, as shown in the wiring diagram.
After each wire and harness is connected, check for proper
connections by referring to the wiring diagram.
34
Hide quick links:
Advertisement
Table of Contents
