Cable Connection - HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service

Cable Connection
Route and connect the control cables t o the remote
control box before connecting them to the motor.
1. Remove the two screws and remove the housing
cover
C.
n
/
\
SCREW
SCREW
\
HOUSING
COVER C
2. Screw in the nut and the shift pivot on the control box
side of the control cable to the position shown.
Screw in the shift pivot 8 m m (0.3 in) or more from the
end of the control cable and tighten the lock nut
securely.
Apply marine grease to the joint of the shift pivot.
NUT
8 mm (0.3 in) or more
\ t 4
I
SHIFT PIVOT
- d G
(Marine grease)
3. Aligning the groove in the shift cable with the cable
guide, connect the shift cable to the control box.
4.
Connect the shift pivot to the shift lever.
n
SHIFT LEVER
SHIFT CABLE
CABLE
'7u
GUIDE
5. Install the cable clamp spacer.
6. Install the throttle cable by aligning the groove in the
cable with the cable guide.
7. Connect the shift pivot to the shift lever.
8. Install the housing cover C with the two screws.
HOUSING COVER C
B
I
/
SCREWS
(2)
/
THROTTLE CABLE
22