HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service page 31

7. Apply marine grease to the joint hole of the shift pivot
and shift link.
8. Adjust the shift pivot until it will attach to the shift link.
9. Attach the shift pivot to the shift link, then tighten the
lock nut securely.
SHIFT LINK ROD
10. Make sure that the shift pivot is in the center of the
shift link joint hole, adjust by turning the shift pivot if
necessary.
SHIFT LINK ROD
11. If necessary, loosen the lock nut and turn the shift
pivot for adjusting.
After adjusting, tighten the lock nut securely.
SHIFT PIVOT
12 Make sure that outboard motor in the neutral position;
shift arm tip aligns with the neutral switch tip and the
detent roller is set in the groove in the shift arm.
DETENT ROLLER
SHIFT
I
NEUTRAL SWITCH TIP
SHIFT ARM TIP
DETENT ROLLER
NEUTRAL
SWITCH
Shift'arm tip
aligns with the
neutral switch tip.
13. After attaching the shift cable to the shift link, check
for smooth operation by moving the remote control
lever to forward and reverse positions.
30