Propeller Installation - HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service

Propeller Installation
Disconnect the battery cable terminal t o prevent the
engine from starting accidentally.
Wear heavy gloves to protect your hands from sharp or
nicked propeller blades.
1.
Apply marine grease to the propeller shaft.
2. Install the thrust washer and the propeller on the propeller
shaft.
THRUST
WASHER
Install the propeller washer and 18 mm castle nut.
TORQUE : 1.0 N m
(0.1 kgfm, 0.7lbf.ft)
SPLIT PIN
\
PROPELLER
18 mm
WASHER CASTLE NUT
Tighten the 18 mm castle nut and secure with the split
pin.
If the split pin does not align with the hole in the
propeller shaft, adjust by turning the nut in the
tightening direction. Do not exceed the maximum
torque.
Maximum tightening torque:
44 N.m (4.5 kgf-m, 32 Ibf-ft)
After installation, bend the split pin ends as shown to
secure.
If the commercially available parts are used, select the
stainless steel parts.
SPLIT PIN
42