FUSES
Electric Starter Will Not
Operate
The 7.5 A, 10 A, 15 A, and 30 A
main fuses protect the electric starter
relay and related circuits.
The main fuse protects the ignition
switch and related circuits. If this fuse
blows, the engine will not start or run,
and the power trim/tilt switch will not
activate the trim/tilt mechanism.
The 40 A fuse is in the power harness
connected to the battery. If this fuse
blows, the engine will not start or run.
Battery Will Not Charge
A 100 A ACG fuse protects the
alternator circuit. If the ACG fuse
blows, the engine will not charge the
battery. Refer to p. 133.
TAKING CARE OF UNEXPECTED PROBLEMS
Fuse Replacement
Disconnect the battery cable at the
battery negative ( – ) terminal before
replacing the fuse.
Failure to do so may cause a short
circuit.
Main Fuse
1. Stop the engine and disconnect the
battery cable.
2. Remove the engine cover.
SPARE FUSES
3 A FUSE
(3A, 7.5 A, 10 A, 15 A, 30 A)
45°
3. Remove the junction box lid.
FUSE PULLER
FUSE
HOLDER
MAIN FUSES
(7.5 A, 10 A, 15 A, 30 A)
JUNCTION
BOX LID
RELAYS
(Do not remove the relays)
131