Shift Cable Connection - HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service

7.
8.
9.
Tighten the grommet with the band securely. Make
sure the fuel tube is not pinched by the grommet.
GROMMET
I
BAND
Connect the main wire harness 14P connector to the
switch panel wire harness connector and the 3P
connector to the indicator panel wire harness connector,
then attach them to the connector holders.
Clamp the switch panel wire harness and the indicator
panel wire harness with the harness clip.
HOLDERS
INDICATOR PANEL
A
HARNESS CLIP
'
SWITCH PANEL WIRE HARNESS
Shift Cable Connection
1. Install the shift pivot to the remote control cable.
2.
Move the control lever to the full forward "F" position.
3. Then slowly return the control lever to the neutral "N"
position, and make a mark (A) on the inner cable at
the end of the outer cable seal as shown.
OUTER CABLE
I
"
N
"
MARK A
I
OUTER CABLE SEAL
4. Move the control lever to the full reverse "R" position.
5. Then slowly return the control lever to the neutral "N"
position, and make a mark (B) on the inner cable at
the end of the outer cable seal as shown.
MARK B
\
"
N
"
I
OUTER CABLE SEAL
6.
Make a mark (C) at the center between the A and B
marks.
MARKC MARKB
MARK A
29