HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service page 26

5.
6.
7.
8.
9.
HOUSING BRACKET
'
Remote the cover and the other parts as shown.
r--/
CONTROL C U S T N
Remove the screw and remove the back plate form
the inner housing.
SCREWS
Apply marine grease to both the shift and throttle pins
at the end of each arm.
In stall t h e gear shift c o n t r o l ca ble g r o o v e i n t h e
housing clamp groove. Insert the cable end into the
pin at the end of the shift arm, and secure with an E-
ring.
Insert the cable clamp spacer in the clamp groove.
SHIFT ARM
CONTROL CABLE
CLAMP GROOVE
(Marine grease)
CABLE CLAMP
10. Apply marine grease to the throttle cable pin where it
connects to the throttle arm.
11. Connect the throttle control cable to the throttle arm,
in the same manner as the gearshift control cable,
with an E-ring.
THROTTLE
(Marine grease)
12. Install the back plate and the housing bracket in the
reverse order of removal.
13. Install t h e r e m o t e c o n t r o l as s h o w n . Be sur e t o
connect the switch wire t o the remote control wire
harness before installation.
SCREWS
CUSHION
,
\ \ \ \ \ \
WASHER
NUT
-
NUT
25