HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service page 22

6. Install the neutral lock block on the reverse side of the
control box with the two screws.
I
NEUTRAL LOCK BLOCK
7. Install the control lever from the housing B side in the
neutral position.
Align the groove in the switch wire grommet with the
cutout in the housing B.
Pass the power trim/tilt switch harness as shown and
connect the connector.
Install the power tilt cord clamp with the two screws.
8.
9.
POWER TRIM/TILT SWITCH WIRE
\
CONTROL LEVER
\
SCREW
/
\
POWER TILT CORD CLAMP
CONNECTOR
10. Tighten the 8 mm lock bolt with washer.
TORQUE: 20 N.m (2.0 kgf.m, 14 Ibf.ft)
8 mm LOCK BOLT
WASHER
11. Install the housing cover C and tighten the two screws.
.
Do
not overtighten the screws.
TORQUE: 2 N.m (0.2 kgf-m, 1.4 Ibf-ft)
SCREWS
n
HOUSING COVER C
21