Table of Contents
Advertisement
Control Box Installation
Side Mount Control Box
This control box is designed to be mounted on the starboard
side. When it is mounted on the port side, reverse the control
lever installation for the port mount type (see page 18).
Set a spacer between the control box and the boat to
obtain the clearance for operation of the lever.
Connect the control cable t o the control box before
installing the control box.
1.
2.
3.
4.
5.
6.
7.
Select the control box installation position for boat
and suitable type of the control box.
Recommended installation position:
-
Convenient for the control lever operation
-
Free from interference or restriction in routing the
cables and harnesses between the control box and
the outboard motor.
-
Near a corner of the driver's seat.
-
Underside of the control box is level with the upper
surface of the seat.
Set the remote control box
at
the installation position
and mark the drilling points for the control box mounting
screws.
Drill at the marked points using the 7 mm-diameter
drill.
Connect the control cables to the remote control box
(see page 22).
Install the remote control box using the washers, nuts
and the screws.
Set the spacer and washers between the remote control
box and the mounting surface on the boat as shown
to obtain the clearance for smooth operation of the
control lever.
Install the control box with the control lever set in the
neutral position.
CONTROL BOX
\
SPACER
6 m m SCREW
WASHERS
\
NUT
Top Mount Control Box
Select the remote control installation position on the boat.
Install the remote control in the position that allows
proper remote control lever operation, and where the
cables and harnesses can be routed properly without
strain between the remote control and the outboard
motor.
MINIMUM:
(8.46 in)
Obtain adequate space between the
bottom
of
the remote control and
the surrounding parts so that the
remote control does not interfere
with any of the surrounding parts
(e.g. steering wheel, etc.).
Do not bend the cables and harnesses
sharply. Route the cables
I
harnesses
with the bending radius of 300 mrn
(11.8 in) or more.
Recommended Installation Position
See the following drawings for the space necessaw to install
the remote control.
222 m m
I
(8.74 in)
I
138 m m
211 rnm
(8.31 in)
-
1
171 mrn
(2.95 in)
(6.37 in)
(5 in)
23
Hide quick links:
Advertisement
Table of Contents
