HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service page 25

Hide thumbs Also See for BF200A:
Table of Contents

Advertisement

Both the single and the dual lever type remote controls
are available in the right-hand handle type and the left-
hand handle type respectively. Select the correct type
for the boat.
Remote Control
LEFT-HAND HANDLE
RIGHT-HAND HANDLE
SINGLE LEVER TYPE
SINGLE LEVER TYPE
Control Cable
Control Cable Routing
Top mount
control:
Measure the control cable routing length along the actual
cable route, and add 300
- 450
m m (11.8
-
17.72 in) to the
measurement.
Measure the control cable routing length to the respective
outboard motors.
Dual
mount remote control:
Bending the control cable sharply (i.e. w i t h small
bending diameter) will increase the remote control lever
resistance, which will cause the remote control to fail.
Cable bend diameter must never be less than 600 m m
(24 in).
If the cable loop is to small at the motor end, there will
be an increase load on the control lever operation
resulting in a shorter service life of the cable and
controls. The control cable loop at the motor end should
be long enough to provide unrestricted outboard motor
movement when it is tilted u p / d o w n and steered.
TOP MOUNT TYPE
TELEFLEX UNIVERSAL
OR
MORSE 33C CABLE
-
33C Cable and Cable End Installation
Screw on the cable end over the threaded part
a t
the
end of the control cable and secure with the lock nut not
to allow the cable end to turn.
END
\
Screw in the cable end fully to the end
to the shaded part in the drawing.
Top Mount Remote Control Installation
(Right-hand handle, Single lever type)
This section explains the installation procedure of the
right-hand handle single lever type remote control. The
left-hand handle single lever type remote control and the
left-hand
/
right-hand handle dual lever type remote
controls can be installed in the same manner.
Attach the drilling template (include i n k i t of the
remote control box) to the remote control mounting
surface using pieces of adhesive tape.
Drill the installation holes
and
cut out the center.
Install the control cushion around the opening and
spacer (if used).
Pass the remote control wire harness and the control
cables along the route properly.
MOUNTING SURFACE
24

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bf175aBf225a

Table of Contents