Front Separate Cover Installation; Electric Parts Cover Installation - HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service

I
Front Separate Cover Installation
1. Install the front separate cover and tighten the bolts
securely.
FRONT 6 mm
SEPARATE COVER WASHER
\
6 x l 7 m m
SPECIAL BOLT
6x37mm
SPECIAL BOLTS
2. After installing the cables and wire harnesses to the
motor, remove the bolts, nut and the bracket from the
steering arm.
NUT
Electric Parts Cover Installation
1. Install the cover lightly so that the plastic knobs align
with the holes of the grommets.
ELECTRIC PARTS COVER
PLASTIC KNOBS RUBBER STRAP
GROMMETS
ENGINE COVER
MOUNTING BOSSES
(check for proper alignment with
electrical parts cover)
2. Install the electrical parts cover and secure with the
rubber strap.
Make sure the electrical parts cover is properly
aligned with the engine cover mounting bosses.
1
NOTICE
1
To install the cover securely, make sure the remote
control cable, switch panel wire harness and the
indicator wire harness are installed securely.
If the electrical parts cover is pushed hard and the
plastic knobs are not aligned with the grommets, the
plastic knobs may break.
The electrical parts cover must be installed correctly
to allow the engine cover to insert into the engine
cover mounting bosses.
32