Table of Contents
Advertisement
SWITCH PAN E
UI
N D I CAT0 R PAN E 1
Switch Panel Installation
When the panel mount control box or the top mount
control box is used, install the switch panel on the boat at
the position near the driver's seat.
1. Determine the switch panel installation position.
It should be near the driver's seat where the switch
panel does not interfere with the driving operation.
2. Attach the template shown a t the end of this manual
at the switch panel installation position.
3.
Drill the holes according to the indication on the template.
4.
Install the switch panel by tightening the four 5 x 40
m m screws, four 5 m m washers, four 5 m m spring
washers, and the four 5 mm flange nuts.
5 mm SPRING
WASHERS
(4)
5 mm
FLANGE
NUTS (4)
SWITCH PANEL
Indicator Panel Installation
1.
Determine the indicator panel installation position.
2. Attach the template shown at the end of this manual
at the indicator panel installation position.
3.
Drill the holes according to the indication on the template.
4.
Install the indicator panel by tightening the four 5
x
40
m m screws, four 5 m m washers, four 5 m m spring
washers, and the four 5 mm flange nuts.
Clamp the indicator panel wire harness with the cable
clamp to prevent damage to the harness caused by
vibration.
5.
INDICATOR PANEL
5 x 40 mm SCREWS (4)
/
\
5 mm FLANGE NUTS (4)
CABLE CLAMP
INDICATOR
:I"
HARNESS
33
Hide quick links:
Advertisement
Table of Contents
