Operation Check List - HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service

OPERATION CHECK LIST
In the Water
OUTBOARD MOTOR INSTALLATION
OCheck that there are no water leaks from the motor
OCheck for the balanced weight distribution in the boat.
mounting bolt holes.
OUTBOARD MOTOR OPERATION
OCheck the neutral switch for proper operation.
UTurn the ignition switch ON and check whether the
UTurn the ignition switch ON and check whether the PGM
OTurn the ignition switch t o the START position and
OCheck the outboard motor for any abnormal noise.
OCheck to be sure cooling water flows out of the cooling
buzzer sounds twice.
light, charging light and the OP light come ON.
check whether the engine starts.
system indicator.
After the engine warms up:
OMake sure the motor returns smoothly to idle.
ClCheck idle speed.
OSnap the throttle and check the engine response.
securely.
IDLE SPEED: 650
2 50
rpm
OCheck to see that the emergency stop switch functions
LEAKS
OMakes sure that there are no leaks from the fuel lines
and/or connections. If necessary, repair immediately.
OCheck the outboard motor for cooling water/oil leaks.
Repair if necessary.
DCheck the exhaust system for gas leaks.
During Sea Trials
OCheck the gearshift operation with the remote control
lever.
OCheck the motor operation at trolling speed. Use the
minimum amount of the throttle opening necessary to
operate the boat at a safe trolling speed for 15 minutes.
ODual Motors:
Adjust the tie bar length so that the motors toe-out.
Toe-out is when the motors' forward measurement is
wider than the motors' after measurement.
Motors will toe-out (viewed from the stern) will ensure
better boat stability. It is best if the wakes of two motors
joint 20
-
25 m (66
-
82 ft) stern.
- l
2
2 0 - 2 5 m (66-82ft)
I
Not all boats will follow this specification. Consult your
boat manufacturer for toe-in or toe-out recommendation.
PROPELLER SELECTION
OCheck the engine rpm with the boat under way.
Before engine break-in, avoid continuous full throttle
operation (100 %throttle opening). Do not run the outboard
motor at full throttle for more than 2 minutes at a time.
MAXIMUM RECOMMENDED ENGINE SPEED:
5,000 - 6,000 rpm
OMake sure that there i s no propeller ventilation in a
straight line. There is the possibility of some propeller
ventilation when turning at full throttle with the motor
trimmed out.
After Sea Trials
CHECK & CLEAN THE OUTBOARD MOTOR
OCheck that there is no water in the gear oil.
OCheck that there are no signs of fuel, oil or water leaks.
Repair if necessary.
UAfter running in salty or dirty water, use a flushing kit to
flush the cooling system with clean water. Run the outboard
motor at idle during flushing for approximately 10 minutes.
OClean the entire outboard motor thoroughly with a
cloth.
UCheck the outboard motor for external damage, defects,
or cracks.
I
47