Cable/Electrlcal Co"Ectlon - HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service

CABLE/ELECTRICAL CONNECTIONS
(motor side)
Route and connect the control cables to the remote control
box before connecting them to the motor.
Route the starter cable to the front cover bracket.
Position the white tape mark on the starter cable
aligns with the edge of the front cover bracket.
WHITE TAPE
w
MARK
/
STARTER CABLE
FRONT COVER BRACKET
Pass the fuel tube, indicator panel wire harness,
starter cables, switch panel wire harness through the
grommet.
I W W T E ~ O N T R O L CABLE
(Shift control)
\
(Throttle control)
REMOTE CONTROL CABLE
GROMMET
INDICATOR PANEL
WIRE HARNESS
FUEL TUBE
SWITCH PANEL
WIRE HARNESS
STARTER CABLES
View from outside
Install the grommet by aligning it with the groove in
the front cover bracket.
OMMET
I
FRONT COVER
GROOVE
BRACKET
4.
Position the tie-wrap band on the switch panel wire
harness and indicator panel wire harness at the inside
of the grommet.
TIE WRAP BAND
~
TIE WRAP BAND
GROMMET
5.
Install the remote control cable plate with the 6 x 16
mm hex bolt.
REMOTE CONTROL
CABLE PLATE
6. Install the remote control cables by aligning it with
groove in the remote control cable plate.
\
REMOTE CONTROL
REMOTE CONTROL
CABLES
he
28