Meter Wire Connection; Meter Wiring Diagram - HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service

Meter Wire Connection
Route and connect the wire harness properly, as shown in
the wiring diagram.
Use Meter Wire Harness A and B for meter.
Connect leads and terminals securely. Make sure terminals
are waterproof.
Use 19-gauge (1.25 m m diameter) wire.
Connect the connectors securely. If a terminal is oxidized
or corroded, remove the oxidation or corrosion with a
nonconductive plastic scrub pad or contact cleaner before
reconnecting it.
Make sure insulators surround their connectors completely
and that the ends are not folded up.
Do not break the wire harness coverings. If the covering of
a wire broken, either repair it with electrician's tape, or
replace it.
Attach unused terminals to the adjacent main harness
with a piece of vinyl tape so that the terminals don't interfere
with the surrounding parts.
Connect each wire properly, as shown in the wiring diagram.
After each wire and harness is connected, check for proper
connections by referring to the wiring diagram.
Connect the battery and turn the main power on to check
for proper operation.
Meter Wiring Diagram
See wiring diagram at the end of this manual for wire color.
LIGHT SWITCH
\
BI/V
r-
I
1
1
I
I
I
I
I
I
This is an independent engine-control system. Do not
attempt to integrate it with the boat's system or other
accessories, except for the instrument light switch.
There are three ways to illuminate the instrument lights:
Connect a commercially available switch (Teleflex 1A
16970 or equivalent) between the BI/Y and R/W
terminals.
Connect 12 V
(+)
from the boat's instrument lights to the
R/W term i na I.
Connect the
B W
and
R / W
terminals together for "lights
onR with the engine switch.
TACHOMETER TRIM METER SPEEDOMETER HOUR METER VOLT METER
\
I
1
' I
I
I
I
T L
1
I
I
I
METER WIRE HARNESS B
To: TILLER HANDLE BRACKET or SIDE-SURFACE
MOUNT CONTROL
or
SWITCH PANEL
L
METER WIRE HARNESS A
38