Reversing Control Lever - HONDA marine BF200A Set-Up, Installation, And Pre-Delivery Service

Reversing Control Lever
This side mount control box is available designed to be
mounted on the starboard side. It can be mounted on the
port side by reversing the control lever installation in the
following procedure.
1. Remove the t w o screws and remove the housing
cover C.
HOUSING
COVER C
SCREWS
2.
3.
Remove the two screws and remove the hold-down
plate.
Disconnect the power trimhilt switch harness connector.
HOLD-DOWN PLATE
,
CONNECTOR
4.
Set the control lever in the neutral position.
Remove the 8 mm lever lock bolt and remove the control
lever with care not t o damage the power trim/tilt
switch harness.
CONTROL LEVER
5. Remove the two screws and remove the neutral lock
block.
NEUTRAL LOCK
BLOCK
20