Yaesu FT-100D Operating Manual page 97

Menu Operation
MENU MODE SELECTIONS AND SETTINGS
Menu Item 62 [RX LSB CAR)
Function: Set the Rx Carrier Point for LSB.
Available Values: +500 -
~200
Hz (In 10Hz steps)
Default: 0 Hz
Changing this value is analogous to rotating the IF Shift control, allowing you to preset the
frequency response of the receiver's IF passband during LSB operation.
Menu Item 63 [RX USB CAR)
Function: Set the Rx Carrier Point for USB.
Available Values: +500 -
~200
Hz (In 10 Hz steps)
Default: 0 Hz
Changing this value is analogous to rotating the IF Shift control, allowing you to preset the
frequency response of the receiver's IF passband during USB operation.
Menu Item 64 [TX LSB CAR)
Function: Set the Tx Carrier Point for LSB.
Available Values: +500 - ~200 Hz (In 10Hz steps)
Default: 0 Hz
This is the same function as that of Menu Item 62, as applied to your voice response on
LSB (Tx). The effect may be difficult to discern, however, depending on the setting of the
TX Equalizer via Menu Item 16.
Menu Item 65 [TX USB CAR)
Function: Set the Tx Carrier Point for USB.
Available Values: +500 -
~200
Hz (In 10 Hz steps)
Default: 0 Hz
This is the same function as that of Menu Item 63, as applied to your voice response on
USB (Tx). The effect may be difficult to discern, however, depending on the setting of the
TX Equalizer via Menu Item 16.
Menu Item 66 [5167.5 kHz): U.S.A. Version only
Function: Enable Tx/Rx operation on the Alaska Emergency Channel, 5167.5 kHz.
Available Values: on/oFF
Default: oFF
When this Menu Item is set to on, the spot frequency of 5167.5 kHz will be enabled. To get
to this frequency, use the SELECT knob to navigate; the Alaska Emergency Channel will
be found between the Memory channel "300" and "DUP 001."
Note:
Use of this frequency is restricted to amateurs operating in (or within 92.6 km ot) the
U.S. State of Alaska, and it is to be used for emergency communications only (involving
the immediate protection of life or property).
FT-JOO
MICRO MOBILE OPERATING MANUAL
95